HJ Property Care & Tree Service
Questions to ask before you hire an irrigation company
Irrigation

Questions to ask before you hire an irrigation company

Reviewed by Adam Hurlbert, Owner & Founder, 15+ years in landscape & property care

HJ Property Care Team··5 min read·Last updated

Ask how they find a fault before they start replacing parts, how they blow out a system and where the air goes in, who tests the backflow preventer, whether they repair systems they did not install, how they avoid cutting lines when they dig, and whether they can show proof of insurance. The answers tell you more than the price does. Here are the questions worth asking, and what a good answer sounds like.

How will you find the problem before replacing parts?

This is the question that separates a repair from a guess. A good answer describes a process: running each zone in turn, checking coverage and pressure, testing the solenoid and wiring on a zone that will not start, and locating a leak before digging for it. A dead zone is much more often a failed solenoid or a corroded wire splice than the controller, so a company that wants to replace the controller first, without testing at the valve, is starting with the most expensive possibility.

You should come away knowing what is actually wrong, what it will take to fix, and what can reasonably wait until next season.

How do you blow out a system, and where does the air go in?

The answer you want is that the compressor connects at a blowout fitting downstream of the backflow preventer, not through the device. Colorado State University Extension says pressure vacuum breakers and reduced pressure backflow devices must never be blown out with compressed air, because the heat from the air can melt the rubber seals inside. That is how we do it: a separate blowout fitting downstream of the backflow preventer, each zone in turn until the heads run dry, and where the system's configuration allows, the supply piping drained from inside the house.

Ask about pressure too. The same CSU guidance puts the maximum at 80 psi for rigid PVC pipe and 50 psi for polyethylene, and warns that too much pressure can blow nozzles off. A company that knows what your pipe is made of and sets the compressor to match is the one you want.

Who tests the backflow preventer, and when?

In Missoula, the water utility's backflow program requires approved backflow preventers to be installed, maintained and tested annually on all underground irrigation systems. The test has to be done by a certified backflow assembly tester, at least once a year and immediately after an assembly is installed, relocated or repaired, and a test report goes to Missoula Water each time. Outside the city, ask your water provider what applies.

Many irrigation companies, including ours, are not certified testers. That is normal, but the company should say so and explain how the test fits around its work. We install, repair, winterize and start up systems around the backflow assembly and coordinate with your tester so the test happens with the system charged and running. Our guide to backflow preventers and annual testing explains the devices and the rules.

Do you repair systems you did not install?

Most homes come with a system someone else put in, often extended over the years with mixed parts. Ask whether the company works on those, and what it does when a part is no longer made. A good answer is yes, with an honest read on whether a compatible retrofit or a partial rebuild is the better long-term choice. If you are weighing a fix against a new system, see repair the sprinkler system or replace it.

How do you avoid cutting lines when you dig?

Any new trench, valve or head means digging, and digging means a utility locate first. Montana811 asks homeowners to file a free locate request at least three business days before any excavation, and the company should know the process and tell you who is filing it. Public locates may not include private lines such as other sprinkler laterals, invisible dog fence or wiring to an outbuilding, so a careful company also asks what you know about private lines and how the existing system runs.

How will you set up the watering schedule?

A company that installs or repairs a system should leave it programmed sensibly, not on whatever the controller defaulted to. Montana State University Extension's lawn guide says to water in the early morning and as deeply and infrequently as the soil allows, because frequent light watering leads to shallow roots. Ask how the zones are split, how often each one runs, and how the schedule changes through the season. Zones that mix spray heads and rotors are a common fault on systems that were extended over time, because no run time suits both.

What does the estimate include, and what would be extra?

Ask whether diagnosis is part of the price, whether parts and labor are separated, what happens to the lawn a trench crosses, and whether any backflow work, and the retest that follows it, is included. A clear estimate lists the faults found and the fix for each. Our guide to what moves the price of a sprinkler repair goes through the factors.

Can you show proof of insurance?

Ask for a certificate of insurance from the company's agent showing general liability and, if it has employees, workers' compensation. We carry both and will send the certificate on request.

What happens in spring?

A fall blowout is half of the job. Ask whether the same company does spring startup, and how. Lines should be charged gradually rather than hit with full pressure, every zone run to find what winter did, and coverage corrected where heads have sunk or been knocked out of line. Our spring sprinkler startup guide covers the order.

What does a good company sound like overall?

Specific, unhurried and honest about what it does not do. It explains its diagnosis, knows your pipe and your backflow device, tells you who tests the backflow, files or confirms the locate, and gives you a written estimate you can compare. If you want to know more about how a new system goes in, read what to expect when a sprinkler system is installed, or start from the problem in the Montana Property Care Guide.

When you are ready, see our irrigation installation and repair service, book a sprinkler check, or call HJ Property Care & Tree Service at (406) 215-7319.

Need help?

HJ Property Care & Tree Service is locally owned and ISA-certified. Call for a free estimate.

This article is part of the Montana Landscaping, Lawn & Irrigation Guide, our complete guide for western Montana property owners.

Explore our irrigation systems.

Sources

We cite primary sources: Montana State University Extension, the City of Missoula, and the ISA, so you can verify anything here yourself.

  1. Home Sprinkler Systems: Preparing Your Sprinkler System for Winter (Colorado State University Extension). Last checked November 11, 2026.
  2. Public Works Standards Manual Appendix 4-A, Cross-Connection/Backflow Protection Program (City of Missoula / Missoula Water). Last checked November 11, 2026.
  3. Homeowner Hub: file a free locate request before you dig (Montana811). Last checked November 11, 2026.
  4. Maintaining Successful Lawns in Montana (MontGuide MT202004AG, revised 08/23) (Montana State University Extension). Last checked November 11, 2026.

Ready to transform your outdoor space?

Get a free, no-obligation estimate within 48 hours. Locally owned and ISA-certified.